Sliding(Gear) Type Aluminum/Aluminum Alloy Rod Breakdown Drawing Machine
Here share a video about our machine: https://youtu.be/VakZVKHvJXk
Main components(Standard Configuration):
| Configuration items | Qty | |
| FX1650 swing arm pay-off rack | 1 set | |
| HLT450-13 single-head gear type RBD drawing machine | 1 set | |
| YG400 storage wire tension controller | 1 set | |
| HLT630 semi-automatic double-disk take-up machine | 1 set | |
| Electrical control system (Huichuang inverter, PLC, Wannan motor) | 1 set | |
| ZJ430 head rolling machine | 1 set | |
| Gear bearing lubricating oil station | 1 set | |
| Wire drawing liquid supply station (11KW oil pump + 60 square tube cooler + 6 cubic oil tank) | 1 set | |
| Hot welding machine (welding 9.5 aluminum rod) | 1 set | |
| Cold welding machine (J3-A type: welding 1.6-5.0) plus 6 molds (estimated price) | 1 set | |
| Centrifugal filter FY-30A | 1 set | |
| Connecting wires, signal wires, control wires, etc. between electrical cabinets and equipment (except power supply lines and motor lines) | 1 set | |
Main Parameters
| HLT450-13 Aluminum wire inline gear wire drawing machine | |||||
| Production table | |||||
| Production specifications (mm) | Speed (MPM) | Theoretical output/day (Kg) | Actual output/day (Kg) | 1 hour output (KG) | Remark |
| 1.8 | 1400 | 13608 | 11567 | 567 | Ordinary aluminum (strength ≤ 140MPa) |
| 2.2 | 1300 | 18876 | 16045 | 787 | |
| 2.58 | 1300 | 25960 | 22066 | 1082 | |
| 2.89 | 1200 | 30068 | 25557 | 1253 | |
| 3.29 | 800 | 25978 | 22081 | 1082 | |
| 4.2 | 700 | 37044 | 31487 | 1544 | |
| 4.67 | 700 | 45799 | 38929 | 1908 | |
| Note: 1. The production capacity is calculated only at the highest speed per hour, without considering the start and stop of the equipment and the speed reduction of the reel change. The full-day production capacity can be calculated at 90% of the hourly production capacity. | |||||
| 2. The double-reel take-up machine has a 630 high-speed reel, with a bottom diameter of not less than 350 and an inner hole of not less than 125. | |||||
| 3. The maximum production speed also depends on the quality and temperature of raw materials, molds, wire drawing oil. | |||||
| 4. Special-shaped line speed: 60%-70% of the circular line speed of the same cross-section (specifically affected by alloy materials, molds, wire drawing oil, etc.) | |||||
| The above data is for reference only | |||||
Should you require further detailed information, or a quotation, please do not hesitate to contact us. We would be happy to provide additional information or arrange a live demonstration at your convenience.